A transfer set suitable for use on Lister D, DK and F type engines.
Superb quality Lister D type copper head gasket made to exceed the original specification by the use of a superior non asbestos inner material with a rubber binder.
Every gasket needed for a complete rebuild of the Lister D type engine except for the copper head gasket which is available separately.
A high quality Lister D copper fuel pipe with unions to run from the tanks fuel tap to the connection on the bottom of the carburettors float chamber.
All the parts which would be required for a complete overhaul of both the valves on your Lister D engine. These items are available seperatly but if you require all the items buying them together in one go represents a discount of 10% saving you £10.15 on the regular price!
A length of new Simplex Magneto drive chain suitable for use on the Magneto drive of Lister D staionary Engines.
A quality Lister D replacement valve manufactured to original specification with a slotted stem to accept the carrier pin.
A pair of hardened valve caps suitable for use on Lister D engines. Carefully machined to be an exact replica of the originals including the slot to accommodate the valve stem carrier pin. The top surface may look a little rough in the picture but it is just the light on the picture, the surface is actually nicely ground to original Lister spec.
A quality replacement valve guide for the Lister D engine. Manufactured from original drawings using the correct material spec it doesnt get much better than this unless you can find an unused genuine example....which less face it is very remote!
A pair of Lister D type valve spring carriers. Nicely machined and we have even had them Chemi blacked to help prevent corrosion.
Ideal for use with our valves, guides and springs.
A pair of valve stem pins for use on Lister D engines. We have purposefully manufactured these a little over size to allow for final fettling ensuring a perfect fit. You will find them tight when used with our new valves but probably about right for an older valve that has already done some years work. Simple draw filling or even as little as a touch of emery paper should be all that is required to achieve an acceptable fit to your valve and spring carrier.
A pair of quality replacement valve springs for the Lister D type engine.
A big end bush suitable for use in Lister D type petrol engines. Not an original Lister part but of very high quality phospor bronze material and very well made. Tried and tested by many of our customers with very good feedback.
A crankshaft sleeve suitable for use in Lister D type engines. Not an original Lister part but of very high quality material and manufacture. Tried and tested by many customers with very good feedback and approved by David Harris.
Top quality piston ring set for most Lister D type engines. Comprises of four rings, three compression rings for 3" diameter bore by 1/8" wide P/N D14 and one oil scraper ring also 1/8" wide P/N D212.
Sets with 3/16" oil scraper rings are also
